CDQRC - ALUMIGRIP LINEAR POLYURETHANE TOPCOAT-COLOR BASE
- MSDS: CDQRC
- Manufacturer: US PAINT CORP (FORMERLY GROU GROUP INC)
- Product Name: ALUMIGRIP LINEAR POLYURETHANE TOPCOAT-COLOR BASE
- National Stock Number: 8010-00F004240
Product Identification
Product ID:ALUMIGRIP LINEAR POLYURETHANE TOPCOAT-COLOR BASE
MSDS Date:11/14/1990
FSC:8010
NIIN:00F004240
MSDS Number: CDQRC
Responsible Party
ST LOUIS, MO 63103-3043
US
Emergency Phone: 314-621-0525/202-483-7616
Info Phone: 314-621-0525/202-483-7616
Cage: EO831
Contractor
Telephone: 314-621-0525
Cage: EO831
Ingredients
CELLOSOLVE ACETATE (ETHYLENE GLYCOL ETHYL ETHER ACETATE),
CAS: 111-15-9
RTECS: KK8225000
Fraction By Weight: 10-27%
OSHA PEL 100 PPM
ACGIH TLV: 5 PPM SKIN
DIISOBUTYL KETONE
CAS: 108-83-8
RTECS: MJ5775000
Fraction By Weight: 2-4%
OSHA PEL 50 PPM
ACGIH TLV: 145 MG/CUM
PROPYLENEGLYCOL MONOMETHYL ETHER ACETATE,
CAS: 108-65-6
RTECS: AI8925000
Fraction By Weight: 5-25%
XYLENE, DIMETHYLBENZENE, XYLOL (IARC - GROUP 3) *96-4*
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: 3-5%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM, SKIN
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
475-592 MG/L
RTECS: 9999999VO
Hazards
LD50 LC50 Mixture:ORAL LD50 (RAT): 3.2 G/KG
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE SEVERE IRRITATION.
SKIN: CAN CAUSE MODERATE IRRITATION, DERMATITIS. CAN PENETRATE
SKIN. INHALATION: CAN CAUSE NASAL & RESPIRATORY IRRITATION. MAY
CAUSE ASPHYXIATION. INGESTION: HARMFUL /FATAL, CAN CAUSE BURNING
SENSATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
DEFATTING, DIZZINESS, WEAKNESS, FATIGUE, NAUSEA, HEADACHE,
UNCONSCIOUSNESS, TIGHTNESS & CHEST, SORE THROAT, VOMITING, DIARRHEA
First Aid
First Aid:SKIN: WASH AREA THOROUGHLY W/SOAP & WATER. EYES: FLUSH
W/LARGE AMOUNTS OF WATER FOR 15 MINS. INGESTION: DON'T INDUCE
VOMITING. ASPIRATION INTO LUNGS CAN CAUSE CHEMICAL PNEUMONITUS
WHICH MAY BE FATAL. INHALATION: IF DIFFICULTY BREATHING, GIVE
FRESH AIR. IF BREATHING HAS STOPPED GIVE CPR. OBTAIN MEDICAL
ATTENTION IN ALL CASES.
Fire Fighting
Flash Point Method:TCC
Flash Point:82F
Lower Limits:1.1
Upper Limits:7
Extinguishing Media:DRY CHEMICAL/FOAM
Fire Fighting Procedures:USE SCBA W/FULL FACE-PIECE OPERATED IN
POSITIVE PRURE MODE. TOXIC GASES & SMOKE MAY BE PRESENT. CLOSED
CONTAINERS MAY EXPLODE DUE TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP AWAY FROM HEAT, SPARKS & FLAME.
EXTINGUISH ALL PILOT LIGHTS & TURN OFF ALL SOURCES OF IGNITION
INCLUDING NON-EXPLOSION PROOF ELECTRICAL EQUIPMENT.
Accidental Release
Spill Release Procedures:SMALL: ABSORB LIQUID ON INERT MATERIAL SUCH AS
PAPER, VERMICULITE, FLOOR ABSORBENT & TRANSFER TO HOOD. LARGE:
ELIMINATE ALL IGNITION SOURCES. EVACUATE ALL UNPROTECTED PERSONNEL.
STOP AT SOURCE. CONTAI N & PUMP LIQUID TO SALVAGE TANK. (SUPP)
Handling
Handling and Storage Precautions:KEEP CLOSURE TIGHT & UPRIGHT TO
PREVENT LEAKAGE. KEEP CONTAINER CLOSED WHEN NOT IN USE. DON'T STORE
ABOVE 120F.
Other Precautions:DON'T TRANSFER CONTENTS TO BOTTLES/OTHER UNLABELED
CONTAINERS. EMPTY CONTAINERS RETAIN PRODUCT RESIDUE.
Exposure Controls
Respiratory Protection:APPROPRIATE, PROPERLY FITTED NIOSH/MSHA APPROVED
RESPIRATOR DURING & AFTER APPLICATION UNLESS VAPOR, MIST &
PARTICULATE LEVELS ARE BELOW APPLICABLE LIMITS.
ENGINEERING/ADMINISTRIVE CONTROLS SHOULD BE IMPLEMENTED TO REDUCE
EXPOSURE.
Ventilation:USE W/ADEQUATE VENTILATION. MAINTAIN CONTINUOUS FLOW OF
FRESH AIR. PROVIDE MECHANICAL(GENERAL/LCAOCAL)TO KEEP BELOW TLV.
Protective Gloves:SOLVENT IMPERMEABLE
Eye Protection:SOLVENT RESISTANT W/SPLASH GUARDS
Other Protective Equipment:SOLVENT IMPERMEABLE CLOTHING & BOOTS TO
PREVENT SKIN CONTACT.
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
SPILLS CONT'D: ABSORB REMAINING LIQUID W/INERT ABSORBENT. PREVENT
RUNOFF TO SEWERS, STREAMS/OTHER BODIES OF WATER.
Chemical Properties
Boiling Pt:B.P. Text:278F
Vapor Density:>1
Spec Gravity:1.05-1.31
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:LIQUID W/SOLVENT ODOR
Percent Volatiles by Volume:50-63
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZING
MATERIALS,POTASSIUM-TERT-BUTOXIDE,PERMANGENATE,CHLOROFORM,CHLORO
SULFONIC ACID,HYDROGEN PEROXIDE,NITRIC ACID
Stability Condition to Avoid:EXCESS HEAT
Hazardous Decomposition Products:FUMES CONTAINING CO, CO2
Disposal
Waste Disposal Methods:ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD
BEING SURE TO ALLOW SUFFICIENT TIME FOR VAPORS TO COMPLETELY CLEAR
HOOD DUCT WORK. DON'T INCINERATE CLOSED CONTAINERS. DISPOSE OF
IAW/FEDERAL, STATE & LOCAL REGULATIONS. UN 1263
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.